Lately there have been several comments made by experienced photographers stating that selecting different focus areas in the camera will change the place in the image that the flash meters from. I knew that this wasn't true based on my knowledge gained by designing flash and camera integrated circuits. I knew that the flash meters the entire frame based on center weighted brightness. However, I needed some proof, so I took the following series of images.
Firts, I arranged a white panel and a black panel so that they split the frame exactly in two. These images are unedited, directly out of my D3, low ambient conditions, f/5.6, 1/200th, ISO 400, regular TTL.
In image 1 (below), , the focus point was moved to the far left in the center of the white panel (the panel appears gray, because the flash system has averaged the center weighted frame and chosen a power that balances the entire image to Nikon’s meter 12% gray reflectance.
In image 2, I moved the focus spot all the way to the right side in the middle of the black panel. Notice that this image is exactly the same exposure as Image 1) showing that the position of the focus point is not used for the regular TTL metering system.
In the next few images, I investigate the effects of the focus system on TTL compared to TTL-BL.
In image 4, next, (still in TTL mode) I moved the focus point to the far right on the rope extending below the hats, and allowed the camera to focus there. You can see that moving the focus point did not affect the flash metering. The subject (although now out of focus) is exactly the same brightness as the previous image, as is the background.
In image 5 I switched to TTL-BL mode and placed the focus point back on the statue. You can see that the statue is no longer overexposed, as the balancing equations try to balance it with the darker background.
In image 6 I remained in TTL-BL mode and moved the focus point to the far right so the rope below the hats would be in focus. Immediately you see a change in the flash power. The statue is now overexposed and the background is much brighter. This is what has been causing even experienced photographers to think that the focus selection has an effect on flash power. However, the change is not being caused by moving the focus points. It is being caused by the change in focus distance. In this image the hats are about 15 feet behind the statue, and in TTL-BL mode, the distance is the prime factor that is used to set flash power. So, the farther distance caused the power to increase.
In image 7, I left the flash in TTL-BL mode, and switched off the auto focus and moved the focus point back to the statue. the important thing to notice is that the exposure of this image is identical to the previous image. This proves that moving the focus point does not affect flash power.
In image 8, I moved the focus point back to the hats. Again the exposure did not change.
These images prove that moving the focus point does not affect flash metering in either TTL or TTL-BL flash modes. The change in exposure that has been observed in TTL-BL mode when moving focus points is due entirely to the change in focus distance as reported by the D lens.
Editors’ note: Contrary to popular belief, Nikon meters (and Canon’s) are calibrated for 12% gray reflectance, according to ANSI standards (ISO 2720:1974). The correction needed if you are metering off a Kodak 18% gray card is ½ of an f-stop.
More articles that might interest you