I am often asked how to set up your camera and flash for a given lighting situation. This article will give you a 'cookbook' approach that should lead to excellent results.
NOTE: For this post I am assuming regular flash sync - Not Auto FP High Speed Sync
NOTE: On some speedlights, including the SB-400, SB-700, and the built-in Pop-Up flash, there is no selector for i-TTL and i-TTL|BL. To switch between these two modes on these speedlights, you switch the camera metering mode. Matrix and Center-Weighted force the speedlight into i-TTL|BL mode. Spot metering forces the speedlight into regular i-TTL mode.
Use your camera to measure the light! Here are the steps:
1) Camera in Manual mode
2) Flash turned OFF
3) Fixed ISO 400 (not Auto ISO)
4) Aperture: f/4.0
5) Aim your camera at the area you want to measure
6) Adjust the shutter to zero the meter
The resulting Shutter speed then will indicate the ambient lighting condition you are in as follows:
1) Low Ambient Light: Shutter 1/30th or less
2) Medium Ambient Light: Shutter 1/30th to 1/250th
3) High Ambient Light: Shutter above 1/250th
I. LOW AMBIENT LIGHT: In low ambient conditions, your flash will be primary and essentially the only light on the subject. The ambient will contribute only to the background exposure.
Recommended Initial Settings: Camera Manual, Flash i-TTL, ISO 400, f/4.0, 1/80th shutter.
The flash system will control the exposure of the subject no matter you do to the ISO, Aperture, or Shutter (within the range limits of the flash).
The shutter will primarily control the background exposure. Increase the shutter to stop ghosting at the expense of a darker background. Decrease the shutter to brighten the background, at an increased risk of ghosting.
The aperture will primarily control depth of field. Widen the aperture to decrease depth of field, increase background exposure, and increase flash range. Narrow the aperture to increase depth of field, decrease background brightness, and reduce flash range.
II. HIGH AMBIENT LIGHT: In high ambient conditions your flash will be adding FILL. This means the flash will be secondary to the ambient light in creating your images. The flash will brighten the shadows on the subject's face and clothing. The power of the flash must be adjusted to balance with the ambient light to make the subject equal brightness to the background ambient. You should use i-TTL-BL flash mode to allow the flash to adjust itself automatically to balance the subject with the ambient.
If direct sunlight is hitting the subject's face, move the subject into the shade. If that is not possible, turn off the flash to avoid overexposure (blow out) of the subject's face.
Recommended initial settings:
Camera P mode, ISO 200, i-TTL-BL
This is the simplest setting I recommend at first until you more fully understand everything. These settings will add nice fill light to your shots.
III. MEDIUM AMBIENT LIGHT: Medium ambient is by far the most difficult situation to use your flash. It is also the time when if you use your flash right, it will greatly improve the quality of your images, but if you use it wrong, it will destroy your images.
In medium ambient you have to make several more decisions to determine the initial settings. You have to decide how you want to shoot:
To read the rest of the article, please log in. This article is available only for registered Nikonians members. If you are not registered yet, please do so. To discover the world of Nikonians and the advantages of being a registered member, take our short discovery tour.
More articles that might interest you