Bracketing Sub-Command Dial
For some reason my Sub-Command dial will not change my exposure!
My menu settings are all correct. I have gone over them again and again.
Yes, menu f5 is set to Fn button + dials BKT
When I hold down the FN button, the Command Dial works perfectly and I can change how many shots I want to bracket (3-9), but when I hold down the FN button and rotate the SUB-Command dial, the exposure bracketing won't change. It just stays on 1.
I am exceedingly frustrated.
I have 'reset' the settings, I have turned it on and off, I have taken out the battery and put it back in, I have switched modes (M, A, S, P), I have removed the flash off my camera, changed formats (RAW, jpg, tiff), etc.
I know none of the above should have any bearing whatsoever, but had to try it.
Any ideas anyone?
#1. "RE: Bracketing Sub-Command Dial" | In response to Reply # 0rb4good Nikonian since 22nd May 2006Sat 02-Jun-12 09:51 AM
Laura, Menu item-metering/exposure,check b2(D300)EVsteps for exposure control 1/3,1/2 or 1,if at 1 in bracketing you will not be able to change it with the subcommand dial.