Film Rewind

1: No auto film rewind. You must rewind the film using the two film rewind buttons pressed at the same time.

 DX Auto or ISO 
 Manual Film speed

1: The film speed must be set manually by setting the Mode Select Dial to ISO and selecting the proper ISO value.

 Bracketing Exposure
 Order

1: While bracketing, the first frame is underexposed, the second uses the metered value, and the third is overexposed. (-, =, +)

 Grid Lines in Viewing
 Screen

1: Viewing screen grid lines enabled

 Focus Area Illumination

1: Focus area sensors never illuminated.

2: Focus area sensors briefly illuminated in red when shutter button is partially depressed, in all light conditions.

 Focus Area Selection

1: Focus area sensor is selected by pressing and holding the thumb rocker switch in any direction. The sensor selection will scroll between the five sensors until the thumb rocker switch is released.

 AE Lock Use from
 shutter release
 button

1: AE Lock does occur as long as slight pressure is maintained on the shutter release button.

 Auto Film Loading

1: Auto film loading is disabled. The film does not advance to frame one until the shutter release button is pressed.

 Closest Subject Priority
 in Dynamic/Single Servo
 Autofocus

1: The camera uses the last selected AF Sensor, according to the position selected previously by the thumb rocker switch. The sensor in use will be highlighted in darker black. 

 Closest Subject Priority
 in Dynamic/Continuous
 Servo Autofocus

1: The camera selects which AF Sensor (of the five) to use. It decides based on the closest and brightest object it can sense in the viewfinder.

 AE-L / AF-L 
 Button Function

 AE = Autoexposure
 AF = Autofocus

1: AE Lock only when AE-L/AF-L button is held down. AF is not locked. (AE Lock, no AF Lock)

2: AF Lock only when AE-L/AF-L button is held down. AE is not locked. (AF Lock, no AE Lock)

3: AE-L/AF-L button toggels AE Lock. If the AE-L/AF-L button is pressed once, the AE stays locked until it is pressed again. (Works like a light switch, on/off)

4: AF is only activated when the AE-L/AF-L button is held down. Partially depressing the shutter release does not cause AF to activate when this mode is selected.

 Command Dial Functions

1: Main-command dial (rear) controls aperture speed. Sub-command dial (front) controls shutter speed.

 Film Rewind Speed

1: Quiet film rewind. (Takes about 23 seconds to rewind a 36 exposure roll)

 Multiple-Exposure Film 
 Advance Rate

1: Shutter is released continuously until shutter-release button is released. (Multiple exposure)

 Auto-Meter Switchoff
 Time Delay

6: Six-second time delay before meter shuts off. **

8: Eight-second time delay before meter shuts off.

16: Sixteen-second time delay before meter shuts off.

 Self-Timer Duration

5: Five-second delay before shutter fires.

10: Ten-second delay before shutter fires. **

20: Twenty-second delay before shutter fires.

 External LCD Panel
 Illumination

1: Pressing any button lights up the top LCD Panel.

 Auto-focus Assist 
 Illuminator Settings

1: AF Assist light does not come on in low-light conditions.

 Data Imprint ISO Speed
 Brightness. (Data imprint
 between frames)

1: Can be manually set for film speeds under 25 ISO.

2: Can be manually set for film speeds of 32-80 ISO.

3: Can be manually set for film speeds of 100 ISO.

4: Can be manually set for film speeds of 125-200 ISO.

5: Can be manually set for film speeds over 200 ISO.