NX2 'Save Adjustments' not working properly
NX2's SAVE ADJUSTMENTS command seems to be misbehaving.
If I try to save two sharpening steps (High Pass and Unsharp Mask) it only saves one of them.
The .set file should contain both steps but when I choose LOAD ADJUSTMENTS only High Pass is there.
Is anyone else getting this?
#1. "RE: NX2 'Save Adjustments' not working properly" | In response to Reply # 0
mklass Nikonian since 08th Dec 2006Wed 17-Jul-13 01:05 PM
I have not had this problem.
Make sure that the checkmarks are set for the adjustments when you save the settings.
When applying, if you get a message about overwriting, say allow it.
Visit my nikonians gallery
#2. "RE: NX2 'Save Adjustments' not working properly" | In response to Reply # 1
Gromit44 Registered since 04th Jan 2012Wed 17-Jul-13 01:29 PM
It's ok Mick, I was having a mental block - I've sussed it out now.
I was saving the adjustment steps by clicking the 'New Step' button, right clicking on the 'Select Adjustment' area, then naming and saving. This doesn't work - there's no need to use New Step.