#5. "RE: Can't Get Multile Exposure with bracketing to work." In response to In response to 0
>I am trying to use multiple exposure with bracketing and >interval timer to do HDR. >1. I am in in Aperture Priority. >2. In Shooting menu I Set Multiple Exposure on for 3 shots >3. In Setup menu e5 Bracketing/flash set to AE >4. I press the bkt button on the left side of the camera and >hold >the exposure compensation button down & try to set set the >bracketing to 3F 2.0 using the front & rear dials. I am >able to do this. >5. Then when I look at the multiple exposure setting it is >reset to OFF. >6. If I set it to on I can't get the bracketing in the lcd >display to say 3F 2.0 -- It just says +2.0 > >If I press the shutter release I get only one overexposed >image and multiple exposure is set to off. > >Does multiple exposure get reset each time you take a shot? > >There seems to be a conflict between the way I am setting up >the bracketing and the multiple exposure setting. Getting very >confused. > >Please advise. Thank you.
Steven. What you are getting is correct but you can't do HDR this way.
Yes. Multiple exposure gets reset to OFF after you take the photo.
Your over exposed photo is what you get when doing multiple exposure using the same scene. You end up with a photo that overlays the frames so everything is brighter.
I don't have a D7000 but I used my D700 instead and the procedure is the same for both cameras.
Here is an example of using 3 bracketed exposures, +/- 1 EV. using the multiple exposure mode. Note blown highlights. This photo is lighter than my +1 bracketed shot.
Here are the same 3 bracketed photos using HDR Pro in CS5. The highlights are slightly darker than the original and the dark trees are brighter.