I've recently bought a D7100 after using the D7000 (which husband now has) and it seems a backward step to me to have to access the menu when I want to use the remote rather than have it on the dial like the D7000. I find it very frustrating when I turn off the camera to move to a new position and have to access the menu to turn the remote back on, especially when shooting in low light.
Am I missing something - and is there another way to turn it on?
#3. "RE: Using remote with my D7100" In response to Reply # 0
Rocky Hill, US
I found the ML-L3 to be a nice gadget to use on a few occasions but not very good for anything else. As you said ,it was a pain to use, even going through the "I" menu and I could never find a way to do a bracket with one push of the button, had to push the button for each image(maybe I had something set wrong ?). Bought the MC-DC2 and now I'm a happy camper. Set a bracket, and push and hold the button and when the bracketing sequence is done, it stops.
#5. "RE: Using remote with my D7100" In response to Reply # 0 Thu 18-Jul-13 07:31 AM by Mycenius
I must say I'm a bit lost by this - on the D90 you used to have to use a menu, but on the D7100 you just switch the dial to remote and the IR remote works - I've used mine a couple of times to do multiple exposures... Or do you mean you can't use the IR remote & multiple exposures *with* bracketing at the same time?
#6. "RE: Using remote with my D7100" In response to Reply # 5
El Sobrante, US
I had the same response as the OP when I tried this on my D7100. On my D90, you could set it to use the IR remote by pushing down the middle button on the top right-hand side of the camera and turning the rear command wheel to the appropriate setting. On the D7100, you have to use a menu or the i button. This is the one area in which I think the D90 was better.