Jus a little curious about what you guys think about AF Assist Illuminator. I went to a Restaurant recently and when I started taking pictures I could't focus (low Light) and the Af Illuminator light was annoying so everybody was looking the light.. How can I do to be able to focus without Af Assistant Illuminator on.. thanks.
I turn mine off. I don't use it for red eye reduction either.
I've yet to pick up an ITTL speedlight (gonna get the SB910), but when I was shooting film, I did the same on my N80. I use(d) an SB28 and that had an IR AF Assist lamp that worked so much better. When its not mounted and AF was spotty, I would just switch to MF.
I was using the 50mm lens focus at 2.8f. and speed 400 taking pictures in a restaurant at a cross the table distance..sitting in a booth table... So in doing this means that I can't take pictures in a dark place with this Nikon D700 camera (unable to focus)?
Brian hit the nail on the head. You will need a faster lens or use a Speedlight or SU-800 that have IR AF Assist lights. Picking an AF target with the most contrast will also help depending on just how low the ambient light level is. Good Luck and Enjoy your Nikons!
I have had the AF Assist light on my D700 turned Off since the day I got it. The D700's AF module is really very sensitive. I assume you are using Single Servo (AF-S) mode with a single AF point. Using the AF target with the highest contrast should help even in very low light. Good Luck and Enjoy your Nikons!
#8. "RE: AF ILLUMINATOR" In response to Reply # 6 Mon 12-Nov-12 08:25 PM by MEMcD
The blur is not an AF problem. It is caused by camera shake. The exposure was 1/3rd sec. Even with a very steady hand getting a sharp image is extremely difficult hand holding at shutter speeds more than twice as fast. Turning up the ISO to about 3200 would get you a shutter speed of 1/80th sec. that should be fast enough to provide a sharp image. Good Luck and Enjoy your Nikons!
#10. "RE: AF ILLUMINATOR" In response to Reply # 9
The AF Assist light built into the SC-29 is powered by the Speedlight attached to the SC-29. Therefore the attached Speedlight must be On and the camera must be set in Single Servo (AF-S) mode for it to work. Good Luck and Enjoy your Nikons!